Bertram33 User Forum

Does anyone know where the fuel tank vent fitting comes out of the tank? I would like to run a new vent hose off of it and rain the original hullside fitting to just under the rub rail.
I am away from the boat and trying to plan ahead. 1970 35'

Pair of 4 blade props 1 3/4" bore 22 x 24" Nibril

Both are clean and have Prop Scan reports from the last several years- I have pulled them every season, cleaned them and had a tune up with the reports
Boat ran very smooth and lots of bite.

$1900 OBO located in NJ

Finally Up and running - Boat unloaded, 1/2 tank of fuel, no generator, water tank empty, no fishing gear. Cruise 27-28knots tops out at 32knots Props could use some more cup based on load, but will be adding all the extra weight today and running a new sea trial before we add cup. Time to get this ...

slow steady progress

Gathering parts is almost a daily adventure- all the small stuff is adding up.
The labor hours is going to be at least twice what I expected

Putting them back together- Next is a trial fit to see how we will make the engine beds and check the hight

Prepping the engines with some new parts and fresh AWGRIP

Cat 3116’s @ 350hp
Going with 5.9 QSB’s 425hp
2/1 gears
Hopefully they fit

This will most likely be the boats 3rd repower, 1970 35'. This time she is getting 5.9 QSB's

Here is the cleaned out engine room.

Shafts are out for a check and attaching new couplers.
New dripless seals going in, all new hoses, etc

Frank, My 35' si on the north west corner of the building @ IRI for the winter this year. The previous owner mounted a Pulpit and windless if you want to check it out. Boat name is Triple S grey hull. Chris

It is in South NJ Between Atlantic City and Philadelphia. Hull is solid and I am in the process of cleaning all the wiring and plumbing out. The pieces are all there. The bottom will even be Blasted clean in the next couple weeks too. Can send pics etc. It was trucked into the yard, and fit on the h...

I currently have cat 3116s 350HP turning 4 blades and can cruise @ 23Knots at 2300rpm Just thinking of a future repower. My boat has a clean fresh bottom (Blasted, barrier coated, Pettit Black Widow) and the struts are faired in.

Selling a 1973 35' Bert hull All the dirty work is done, it is just a clean shell. Bottom is blasted, bilge is clean, all wires removed, all metal removed with exception of struts and rudder, bridge brow removed for easy transport, Get it before I start customizing it and the price goes up....5k OBO...

What is the largest diesel engine package anyone has heard of in a 35'? Thinking of new QSB 380HP Any out there?

Try this place . They were very helpful when I was looking for a hard top. They are in Fort Pierce. http://www.themarineconnection.net/Towers.html I built my own hardtop and then had the pipe work replaced to match the top.